Strangely a day with no rain.

Kind of unusual as of late to get a day with no rain. Just a lot of sunshine and not really hot temperature. Did get into the 90's but it wasn't too bad. Still to warm and humid to spend just a lot of continuous time in the shop. I have been spending time in the short but keeping it to just short durations. Much more bearable to come in and cool off. Trying just to support projects I can do indoor with the occasional trip out into the shop. And leave all the really shop projects until later. Nothing too impressive as far as rain chance in the next several days. Just the scattered thundershower type of rain. About like what we have been getting everyday as of late. For a local check of the outside temperature my gauge says it is about 84°F with 79% humidity. Warm and humid outside tonight. The airport reports the official temperature as 84°F with 74% humidity.

Need to pay my gas bill and my TruGreen bills tonight. Going to do that right now. Got that done so all my bills should be up to date.

No junk calls today. Kind of rare on Saturdays anyway.

No gold and crude report today.

I did burn some incense this morning but not sure what it was. I build a couple of holders for my incense containers to keep all that organized. Just a few pieced of scrap. Better storage now and will keep them together. Even used my pin nailer. Counts as wood working.

For house work today I did my kitchen duty. And more cleaning in the bathroom. Tend not to do a lot of that at a time.

For wood working as mentioned above and I did a little work on the chair. Just cut a piece to help with alignment. Turned my lathe blank. Really vibrated to start. Got that down a lot. Need to trim the ends just a bit. Going to make two short flower pots out of it. Lots and lots of saw dust. Probably need to change the blade on the main scrapper tool. Kind of just rips instead of cutting but that is Okay as the turning goes through several stages of sanding. Cut an opening for a volt meter. Cut some white board to lay out my clock. Got the marbles in today and I think they are going to work. Laid them out on my coffee table and I think I have the spacing about right. Got to print the holders on my 3D printer. Really need to learn how to use that. Kind of scared of it at the moment. Just need to get familiar with it.

Mostly already covered all my project work in wood working

Got two things in from eBay today. My blue clear marbles and my steelstick from JB weld. Ordered some more clamps for my clock. Probably didn't really need them. Smaller than what I have. I will find other uses for them too.

Went for a short drive after running my errand today. Just around. Should put some gas in the truck. Might do that later. Don't know how late the station stays open though. Fresh gas to mix with the old.

Watched more of Lucifer. Added in a few YouTube videos for viewing pleasure. Still haven't checked to see if this is a premium channel free preview weekend. Might have gotten a Netflix movie in the mail today. Haven't checked.

Got the car outside charging. Seems the unscheduled BBQ mode is quite fixed. Just being caution. Make it until November and turn in my lease. Different battery on the new ones.

Tomorrow is LOL Cats day. Sunday as always. Always look forward to it.

Should release my HEB delivery tonight. Will still have tomorrow to add items. Starting to get rather low on supplies.

Shop needs a bit of work to be put up. Don't think I will go for a drive tonight unless it is to get gas for the truck.

Placed my HEB Delivery order. The highest one yet. Kind of lots of unique items and some rarely ordered but needed.

Need to take a break and sort out the shop.

Shop is sorted. Car is put up and I took the truck out for fresh gas. Six gallons. Should be plenty for my truck start, run and drive. Should count tonight as that.

Twist slept with me last night. Pretty much all night. Some nights it is Fozzy.

I think that is going to do it for tonight.